40W 400-470Mhz UHF RF Power Amplifier XDT-UVPA70 f/ Two Way Radios Walkie Talkie

  
40W UHF RF Power Amplifier Amp XDT-UVPA70 Series For Two Way Radios Walkie Talkie Introduction: Applicable people: Self-driving tourists, project site commanders, radio players Applicable objects: handheld radios, relay station, 433M remote control transmitter Function: increase transmit power and expand communication range Features: 1. Powerful 40W 2.13.8V power supply, suitable for most cars 3. With receiving and sending automatic conversion 5. Minimum 0.2W drive 6. Compact size 100 70 60 mm 7.

Small and light 400g 8. Durable shell made from 304 stainless steel 9. With input cable, output cable, and power cord Product Parameters: - Frequency range: 400MHZ-470MHZ - Input power: 1-7W - Output power: 40W - Input voltage: 12-15V - Input current: 12A - Gain: 12dB-15dB - Input & output connector: SMA-K - Power supply connector: XT-30 - Product Size: 100 70 60 mm - Weight: 400g Package Included: - 1 x RF Power Amplifier - 1 x Input Cable SMA-J SMA-J - 1 x Output Cable SMA-J M-K - 1 x Power Cord XT-30 20cm Instructions: Accessories Introduction: One power amplifier, one power cord, one output cable, one input cable Appearance Introduction: - Aluminum heat sink, 2pcs fans, fan grille protection, stainless steel shell, hexagonal screws, silicone feet, laser screen printing - Small size, easy to carry, sturdy stainless steel housing, compact design Interface Introduction: - Input port, antenna port, power supply port, switch (gear selection), signal indicator has 4 grids Introduction of Switch and Gears: - Gear 1: magnify approximately 10 times, input 1W and output 10W; input 2W and output 20W, and so on. Gear 2: about 20 times magnification, input 1W and output 20W; input 2W and output 40W, and so on. Attention: When the power is high, the output power will be compressed.

It means that it is not the input of 5W and then the output is 100W. OFF Gear: The power amplifier is in the through state, and the sending and receiving are not amplified. Indicator Introduction: - When it is on, it means that the power amplifier is in amplifying state; - The more lights lit, the greater the input signal; - Input power indication range, 1 light lit at 0.5W, 3W full mark, minimum 0.1W can be driven. Introduction of Automatic Speed Regulation Fan: At room temperature, the fan speed is very low and there is basically no sound. As the temperature of power amp increases, we can see that the speed of the fan is gradually increasing, about 800 rpm, and there is still no noise. After the power amplifier is full power for 5 minutes, the fan starts to run at full speed, and the speed is about 1800 rpm. If it does not transmit, after the temperature of the power amplifier drops, the fan speed will return to about 800 rpm. When there is only a handset radio and high power is needed. Digital handset radio require high-power and long-distance communication. Self-driving team tour, on-site command, relay station. Usually it cost about 35USD-50USD. If you receive defective item, please kindly notify us within 14 days. The item "40W 400-470Mhz UHF RF Power Amplifier XDT-UVPA70 f/ Two Way Radios Walkie Talkie" is in sale since Wednesday, December 9, 2020. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers". The seller is "diyradio" and is located in Shenzhen. This item can be shipped worldwide.

• Gain: 12dB-15dB
• Input & output connector: SMA-K
• Power supply connector: XT-30
• Product Size: 100 * 70 * 60 mm
• Analog format: For NFM, AM
• Model: DiyRadio-40W
• Country/Region of Manufacture: China
• Band: AM
• Digital system: For P25, C4FM, NXDN, D-STAR
• Type: Power Amplifier
• Features: Analog
• Color: Black
• Power: 40 W
• Brand: DiyRadio
• Frequency range: 400MHZ-470MHZ
• Input power: 1-7W
• Output power: 40W
• Input voltage: 12-15V
• Input current: 12A