Mhz Power Amplifier

HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling

HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling
HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling
HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling
HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling

HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling   HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling
This is a fully assembled and ready to work HF/50 MHz power amplifier on MRF1K50H modern LDMOS transistor. Cooling system perfomance is based on Heat pipes.

A Heat pipe is a sealed copper tube that is under vacuum, and can transfer heat rapidly away from the source. Heat pipe is constructed using a metal tube that is sealed under a partial vacuum. Inside the copper heatpipe is an inner wick lining that acts as a capillary material for a small amount of fluid. As heat is applied to the heatpipe surface in the evaporator region the fluid is heated and as it is under a vacuum it is easier to change it into a vapor.

This phase change from a fluid to vapor creates pressure. As pressure increases the vapor will naturally flow into the cooler section of the heatpipe. Heat is then released as the vapor condenses back into a fluid. The fluid will then flow back into the warm region, where the cycle will repeat while heat is applied to the that section. Output power: 1200W SSB / CW. Supply voltage: + 50V 34A. Power supplies are not included.

Operation bands: 160 6 meter. Protection system: High SWR, high output power, high drain current, overheat 70C.

Cooling system: Heat pipes 6 pcs 8mm diameter, 360W thermal design power. Noise level as low as 21dB (A) at normal operation conditions.

Double low noise cooling FAN. May be used as is or placed in a box. It has two SO239 connectors on rear for input , output, and DB-25M connector for control (LPF band switching and PTT). Frame size: 188 x 178 x 235 mm.

This amplifier use MRF1K50H LDMOS transistors. It is equipped with all protections required for safe operation. SWR on output higher than 2.0:1. Cooling fan speed is being controled by PWM controller board.

Forced mode is engaged when copper heat spreader plate temperature rise above 55C. If temperature rise above 70C the PTT line is being disabled. 70C thermo sensor has 10C hysteresis.

Two lines LCD shows the output power in Watts and SWR on output. Second line is output power bar graf. Protection status LEDs are placed on separate PCB to the front panel. Rear side has 2 coaxial connectors (input and antenna) and 25-pin control.

The control connector is used to select the LPF bands and has +13.8V and PTT input also. Power amplifier protection system: Protection from exceeding the output power of 1200 watts.

Protection against exceeding the maximum drain current of the LDMOS transistor. Protection against overheating - two modes of operation: -when the copper plate is heated above + 45. The accelerated mode of the fan operation is activated to increase the heat removal; -when the copper plate is heated above + 70 ° C, the protection system breaks the amplifier PTT circuit. Protection against exceeding the SWR more than 2.0: 1.

The activation of the SWR protection is independent of the output power level Protection against false / spontaneous band switching in LPF. The activated protection channel is indicated by a lit LED on the front panel of the power amplifier.

To reset the error, it is necessary to switch off and on again the. 50-53.7 V power supply. Amplifier is assembled on aluminum frame, easy to place inside the box of suitable size.

The item "HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling" is in sale since Monday, June 25, 2018. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers". The seller is "y_r3kbo" and is located in Voronezh. This item can be shipped worldwide.

  • Amplifier Class: AB1
  • Modified Item: No
  • MPN: Does Not Apply
  • Country/Region of Manufacture: Russian Federation
  • Custom Bundle: No
  • Max.

    Output Power: 1200W

  • Brand: Unbranded
  • Band: HF
  • Non-Domestic Product: No
  • Supported Modes: CW


HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling   HF and 50MHz power amplifier 1200W SSB/CW LDMOS MRF1K50H with Heat pipes cooling