Tokyo High Power 430MHz All-Mode Linear Amplifier HL-130Usx Working Condition

  
Tokyo High Power 430MHz All-Mode Linear Amplifier HL-130Usx Working Condition. We guarantee the authenticity of the item. However, we will take measures to prevent swapping. Tokyo High Power 430MHz All-Mode Linear Amplifier HL-130Usx in working condition Part 6. This is a Tokyo High Power all-mode linear amplifier for the 430MHz band, and is a working HL-130Usx. Receive amplifier gain: +21dB to -21dB at 433.00MHz. Transmitting amplifier: 47W at LOW, 120W at HIGH (when input is set to 10W).

I have attached the measured values?? of input/output power and current consumption.

Other forced standby functions are working normally. When the input setting is 35W, the output LOW/HIGH switching is disabled (original).

Power cable, red and black, 1m, with terminals (3.5SQx2x2) 1 set. Full sterilization and cleaning of the outer casing, connectors, etc. Rear panel and bottom plate are both re-plated. Rubber feet and screws replacement set.

Forced standby wiring is possible via an RCA pin jack. The function of the core wire of the RCA pin plug can be changed using the slide switch on the main unit. When the DC/SHORT switch is set to short, the core of the RCA pin plug. If you wire it so that it is shorted when transmitting, linear will also transmit.

Orange: RCA plug core wire. Linear transmit/receive switching must basically be operated in forced standby mode. The device is equipped with a circuit that detects the carrier and transmits it.

The coaxial relay operates with a delay, so switching is done with a hot switch. This operation can cause carbon buildup on the coaxial relay contacts and can cause sparks.

This may significantly shorten the life of the relay or cause VSWR detection to become unstable (causing the protection circuit to operate). Be sure to wire this when operating SSB.

It is entirely at your own risk. The HL-130Usx uses a switch to set the input level and operates within that range. Be careful with the input level range. There is only one scratch on the whole item and it is in very good condition.

The bottom and back panels have been re-plated and are in good condition. The entire surface has been disinfected and cleaned, so you can use it without worrying about dirt.

The end of the power cable is equipped with an M6 crimp terminal (for the land end). The control cable wiring is brand new. Accessories include standby cable, power cable, and mobile fixing bracket.

You can order in bulk with other products, and price negotiation ispossible. This applies to all electronic items that have not been tested for operation with respect to junk items. Please check the voltage before ordering.

Except for our overseas compatible products, the voltage is Japanese specification (AC100V 50/60HZ). For those in 120V-240V regions, please use a down transformer. I promise to deliver our products toyou safely, securely, and carefully.

Please check by lists or ask us directly. They will return to their original state when opened. During the end of November to the end of December, most ofshipping will be delayed, so please order for Christmas in November.

Your satisfaction is our priority and I promise to offer a pleasant shopping experience to you. I try to satisfy the customer. Thank you very much for looking at this item. International Buyers - Please Note.

Thank you for your understanding.